The company's main business scope: traffic facilities, road marking paint, marking equipment, luminous paint, thermoplastic forms, parking lot facilities installation engineering, traffic marking project. Increase the material temperature by 5-10 degrees, improve the leveling of the coating, reduce the viscosity of the coating, and make the bubbles discharge Or reduce the temperature of the. It is a large-scale transportation facility manufacturer integrating design, development, production, sales and engineering installation. The factory is located in Xuzhou, the capital of Jiangsu Province. The Art2Life Store Materials for the practice of your art life. When encountering this kind of pavement, we can only balance the paint construction of road marking by secondary priming and adjusting the temperature of road marking paint. There are many loose bubbles on the cement pavement. Strong alkaline cement pavement is easy to blister For this, we can only overcome it by cleaning up the floating ash and secondary bottom oil! Only reduce, not eliminate!Ħ. Otherwise, in addition to foam, it is easy to cause the base oil to dry and explode!ĥ. Add a small amount of water to older latex paint. Remove all impurities, especially organic matter such as leaves or grass. Avoid all temperature spikes, whether high or low. The hot melt marking paint can be applied only after the base oil is completely dry. A few simple techniques can help preserve the lifespan of your paint: Store the paint in a cool, dry place. Foam will also be generated if the base oil is not dry: before the base oil is dry, the solvent in the base oil is not completely volatilized, and foam will be generated when heating and volatilizing. However, Katenda said that about one thousandth of soybean oil (or salad oil) can be added when burning materials, sacrificing the compressive strength of the marking, improving the leveling of materials, reducing foam, and meeting the owner's requirements.Ĥ. Modified asphalt is easy to blister when heated: the coating for highway marking construction such as expressway is often used for modified asphalt, and the modifier often blisters when heated. Pay special attention to the road moisture in the morning and evening of winter.ģ. The ground moisture will produce foam: the wet road moisture will heat and evaporate to produce foam, so the construction can only be carried out after the road is dry. Increase the material temperature by 5-10 degrees, improve the leveling of the coating, reduce the viscosity of the coating, and make the bubbles discharge Or reduce the temperature of the material by 5-10 degrees, increase the viscosity of the coating, and prevent bubbles from sticking up and staying in the marking line.Ģ. Air heating in the pavement cracks: when the temperature of the road marking paint is about 200, it takes 3-8 minutes to dry the marking when the road marking construction paint is applied (covered) on the road to form the marking, during which the air in the thin cracks of the road is heated and expanded to the top. So why does foam appear when road marking paint is used for construction?ġ. Although such defects do not affect the service life, careful observation will affect the beauty. Foam often appears in the scratch of road marking paint construction.
0 Comments
Leave a Reply. |